
Tóm tắt tài liệu kỹ thuật
DULCOTEST RHEIC Pt SE
Engineering summary from PDF text extraction for DULCOTEST RHEIC Pt SE. Verify every value with the OEM datasheet.
Summary
Product identification
- Product Name: RHEIC-Pt-SE
- Order Number: RHEIC-Pt-SE, Order no. 1082281
- Series: Prominent Sensors
- Document Revision: TM DT 041 12/17 EN
Operating limits
- ORP voltage: -1500 ... +1500 mV
- Temperature: 0 … 80 °C
- Max. pressure: 6.0 bar
- Min. conductivity: min. 50 μS/cm
Feed water
- Electrolyte: gel containing potassium chloride with a large KCI reservoir
- Diaphragms: PTFE ring diaphragm
Mechanical / hydraulic
- Sensor shaft material: Plastic
- Sensor shaft diameter:
- 17 ± 0.2 mm (below the ½" NPT thread)
- 22 ± 0.2 mm (below the ¾" thread)
- Fitting length:
- 20 ± 0.2 mm (from the lower end of the ½" thread)
- 60 ± 0.2 mm (from the lower end of the ¾" thread)
- Fitting position: vertical up to +15 °
- Screw-in thread: ½" and ¾" NPT thread
Electrical
- Electrical connection: SN6 plug-in head, rotatable with a ProMinent cable
Controllers
- Compatible Controllers: All DULCOMETER® controllers and solenoid metering pumps types D_4a and delta®
Typical application
- Municipal and industrial waste water
- Cooling water
- Process water
- Water in the chemical industry and paper making
- General use for water with solid fractions
Measuring principle
- Technology: Direct potentiometric measurement, 2 electrodes, double junction, gel electrolyte, large Teflon diaphragm.
Disclaimer: The extracted information may miss figures, footnotes, or revisions. Contractual data must match the OEM PDF revision used on the project.
Official datasheet (PDF)
Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.