Quay lại OLTREMARE
OLTREMARE logo

Tóm tắt tài liệu kỹ thuật

LOW2-4014

Engineering summary from PDF text extraction for LOW2-4014. Verify every value with the OEM datasheet.

Summary

Product identification

  • Model: LOW2-4014
  • Type: Low Energy, Excellent Rejection - Brackish Water Element
  • Configuration: Spiral Wound
  • Membrane Polymer: Composite Polyamide
  • Brine Spacer Material: Polypropylene

Performance

  • Nominal Permeate Flow: 370 gpd (1,4 m³/d)
  • Nominal Salt Rejection: 99,4% (99,0% minimum)
  • Nominal Membrane Area: 19 ft² (1,8 m²)

Test Conditions

(After 30 min of operation)

  • NaCl Solution: 1500 ppm
  • Applied Pressure: 150 psi (10,3 bar)
  • Operating Temperature: 77 °F (25 °C)
  • Permeate Recovery: 10%
  • pH Range: 6,5 ÷ 7,0

Mechanical / Hydraulic

  • Total Length (A): 14.0 inches (355,6 mm)
  • Diameter (B): 3.95 inches (100,3 mm)
  • Connection Diameter (C): 0.75 inches (19,1 mm)
  • Core Tube Extension Feed Side (DF): 1.2 inches (30,5 mm)
  • Core Tube Extension Conc. Side (DC): 1.2 inches (30,5 mm)
  • Weight: 3 lbs (1,4 Kg)

Operating limits

  • Maximum Operating Pressure:
    • Fiberglassed: 600 psi (41,4 bar)
    • Tape Wrapped: 300 psi (20,7 bar)
  • Maximum Temperature: 113 °F (45 °C)
  • Maximum Pressure Drop: 10 psi (0,7 bar)
  • Maximum Feed Flow: 12 gpm (45,4 lpm)
  • Maximum Feed Chlorine Concentration: <0,1 ppm
  • Maximum Feedwater SDI (15min): 5,0
  • Maximum Feedwater Turbidity: 1,0 NTU
  • Feedwater pH: 3,0 ÷ 10,0
  • Minimum ratio of concentrate to permeate flow for any element: 5:1

Other Operating Information

  • Minimum permeate flow for individual elements is 15 percent below listed flow.
  • Elements are vacuum sealed in a polyethylene bag containing less than 1.0% sodium meta-bisulfite.
  • Permeate obtained from the first hour of operation should be discarded.
  • Avoid static permeate-side backpressure at all times.
  • These membranes may be subject to drinking water application restrictions in some countries; please check the application status before use and sale.
  • For element loading, use only glycerine to lubricate O-rings and brine seal.
  • The presence of free chlorine and other oxidizing agents will cause membrane failure; this damage is not covered under warranty.

Disclaimer

This summary is based on extracted text and may not include all figures, footnotes, or the latest revisions. Contractual data must match the OEM PDF revision used on the project.

Official datasheet (PDF)

PDF datasheet

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.