Quay lại OLTREMARE
OLTREMARE logo

Tóm tắt tài liệu kỹ thuật

FOUL1-2540

Engineering summary from PDF text extraction for FOUL1-2540. Verify every value with the OEM datasheet.

Summary

Product identification

  • Model: FOUL1-2540
  • Type: Low Fouling, Neutral Charged - Brackish Water Element
  • Configuration: Spiral Wound
  • Membrane Polymer: Composite Polyamide
  • Brine Spacer Material: Polypropylene

Nominal Performance

Based on the following test conditions:

  • Solution: 1500 ppm NaCl
  • Applied Pressure: 225 psi (15.5 bar)
  • Operating Temperature: 77 °F (25 °C)
  • Recovery: 10%
  • Permeate pH (After 30 min of operation): 6.5 ÷ 7.0

Performance specifications:

  • Nominal Permeate Flow: 650 gpd (2.5 m³/d)
  • Salt Rejection: 98.0% minimum
  • Nominal Membrane Area: 28 ft² (2.6 m²)

Mechanical / hydraulic

Dimensions:

  • Total Length (A): 40.0 inches (1016 mm)
  • Diameter (B): 2.4 inches (61 mm)
  • Connection Diameter (C): 0.75 inches (19.1 mm)
  • Core Tube Extension Feed Side (DF): 1.2 inches (30.5 mm)
  • Core Tube Extension Conc. Side (DC): 1.2 inches (30.5 mm)
  • Weight: 4 lbs (1.8 Kg)

Operating limits

  • Operating Pressure:
    • Fiberglassed: 600 psi (41.4 bar)
    • Tape Wrapped: 300 psi (20.7 bar)
  • Temperature: 113 °F (45 °C)
  • Pressure Drop: 10 psi (0.7 bar)
  • Maximum Flow: 6 gpm (23 lpm)
  • Feedwater pH Range: 3.0 ÷ 10.0
  • Minimum ratio of concentrate to permeate flow for any element: 5:1

Feed water

  • Chlorine Concentration: <0.1 ppm
  • SDI (15min): 5.0
  • Turbidity: 1.0 NTU

Product water

  • Minimum permeate flow for individual elements 15 percent below listed flow.
  • Permeate obtained from the first hour of operation should be discarded.
  • Avoid static permeate-side backpressure at all times.

Handling and Storage Notes

  • Elements are vacuum sealed in a polyethylene bag containing less than 1.0% sodium meta-bisulfite and 10% propylene glycol solution.
  • For element loading, use only glycerine to lubricate o-rings and brine seal.
  • The presence of free chlorine and other oxidizing agents will cause membrane failure, and the damage is not covered under warranty.

Disclaimer

This summary is based on extracted text and may not include all figures, footnotes, or the latest revisions. For contractual data, always refer to the official OEM PDF revision used on your project.

Official datasheet (PDF)

PDF datasheet

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.