Quay lại Mann + Hummel
MANN+HUMMEL logo

Tóm tắt tài liệu kỹ thuật

Bio-Cel 2 Stack

Engineering summary from PDF text extraction for Bio-Cel 2 Stack. Verify every value with the OEM datasheet.

Summary

Product identification

  • Series: 8" X-20 Low Fouling RO Element Series
  • Model: 8040-X201-UWAN
  • Membrane Type: X20 Fully Aromatic Polyamide-Urea Advanced Composite Membrane
  • Configuration: Spiral Wound, Fiberglass Outer Wrap with FoulGuard Technology
  • Active Membrane Area: 400 ft² (37.2 m²)
  • Core Tube: TriSep Style

Operating limits

  • Recommended Applied Pressure: 100 - 300 psi (7 - 21 bar)
  • Maximum Applied Pressure: 600 psi (41 bar)
  • Recommended Operating Temperature: 35 - 113°F (2 - 45°C)
  • Feedwater pH Range: 2 - 11 continuous
  • Chlorine Tolerance: <0.1 ppm
  • Maximum Feed Flow: 80 GPM (18 m³/hr)
  • Minimum Brine Flow/Permeate Flow Ratio: 5:1
  • Maximum SDI (15 minutes): 5.0
  • Maximum Turbidity: 2 NTU

Product water

Performance is based on the following test conditions: 2,000.0 ppm NaCl, 225.0 psi, 25°C, 15% recovery, pH 8.0, 30 minutes operation. Permeate flow is clean water flux at standard conditions; individual element's permeate flow may vary +/- 15%.

  • Permeate Flow (Model 8040-X201-UWAN): 10,400 GPD (39.0 m³/day)
  • Average Salt Rejection: 99.50%
  • Minimum Salt Rejection: 98.50%

Mechanical / hydraulic

  • Element Weight: 45 lbs (20 kg)
  • Length (A): 40.0 inches (1,016 mm)
  • Diameter (B): 7.9 inches (200 mm)
  • Permeate Tube (C): 1.50 inches (38.1 mm)
  • Feed Spacer: 0.028" thick diamond spacer

Disclaimer: This summary is generated from extracted text and may not include all figures, footnotes, or the latest revisions from the original PDF datasheet. For contractual data, always refer to the specific OEM PDF revision used on your project.

Official datasheet (PDF)

PDF datasheet

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.