
Tóm tắt tài liệu kỹ thuật
SanRO HS-4
Engineering summary from PDF text extraction for SanRO HS-4. Verify every value with the OEM datasheet.
Summary
Product Identification
SanRO-HS Heat Sanitizable, High Rejection Reverse Osmosis Composite Membrane Elements are designed for high performance in USP and other high-purity water systems. These elements feature sanitary, full-fit outer-wraps to eliminate "dead flow" areas for maximum bacteria control. SanRO-HS components conform to FDA regulation CFR Title 21.
- Configuration: Sanitary (Full-Fit) Spiral Wound
- Membrane Polymer: Composite Polyamide
Performance
Element Performance for SANRO HS-4 (at 225 psig (1.55 MPa), 1500 mg/L NaCl, 15% Recovery, 77°F (25 °C)):
- Permeate Flow: 2200 GPD (8.4 m³/day)
- Rejection: 99.7%
System Performance (projected values for a 2:2:1 array system operating at 15 GFD (26 LMH) average flux with 500 mg/L TDS feed (NaCl), 80% Recovery, pH 7, 77°F (25 °C)):
- Applied Pressure: 180 psig (1.24 MPa)
- Permeate TDS: 6.6 PPM
Operating Limits
- Maximum Applied Pressure: 600 psig (4.14 MPa)
- Maximum Chlorine Concentration: < 0.1 PPM
- Maximum Operating Temperature: 131 °F (55 °C)
- Sanitizing Temperature/Pressure Max.: 185/25 °F/psig (85/0.17 °C/MPa)
- Operating pH Range: 2.0 - 10.0
- Cleaning pH Range: 1.0 - 12.0
- Maximum Pressure Drop for a vessel: 60 psig (0.41 MPa)
Mechanical / Hydraulic
Elements include interconnector assembly, ATDs, and one brine seal.
- Size 4040:
- A: 40.0 in (102 cm)
- B: 3.98 in (10.1 cm)
- C: 0.750 in (1.9 cm) O.D.
- Area: 90 ft² (8.3 m²)
- Size 8040:
- A: 40.0 in (102 cm)
- B: 7.90 in (20.1 cm)
- C: 1.125 in (2.9 cm) I.D.
- Area: 380 ft² (35.2 m²)
Packaging and Pre-treatment
Elements are enclosed in a sealed polyethylene bag containing less than 1.0% sodium meta-bisulfite solution, and then packaged in a cardboard box. All SanRO-HS elements are heat set at the factory with a one-hour vacuum rinse at 85 °C.
Disclaimer: This summary is based on extracted text and may not include all figures, footnotes, or the latest revisions. Contractual data for any project must match the OEM PDF revision used on that project.
Official datasheet (PDF)
Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.