Quay lại Hydranautics Membranes
Hydranautics logo

Tóm tắt tài liệu kỹ thuật

LFC3-LD-4040

Engineering summary from PDF text extraction for LFC3-LD-4040. Verify every value with the OEM datasheet.

Summary

Product identification

  • Membrane Element: LFC3-LD-4040 (Low Fouling Technology)
  • Type: Low Fouling Spiral Wound
  • Membrane Polymer: Composite Polyamide
  • Membrane Active Area: 80 ft² (7.43 m²)
  • Feed Spacer: 34 mil (0.864 mm) with biostatic agent

Performance

  • Permeate Flow: 2,100 gpd (7.95 m³/d)
  • Salt Rejection: 99.7% (99.5% minimum)

Performance is based on the following test conditions (initial data taken after 30 minutes of operation):

  • 1500 PPM NaCl solution
  • 225 psi (1.55 MPa) Applied Pressure
  • 77 °F (25 °C) Operating Temperature
  • 15% Permeate Recovery
  • 6.5 - 7.0 pH Range

Note: Permeate flow for individual elements may vary +25/-15 percent.

Operating limits

  • Maximum Applied Pressure: 600 psig (4.14 MPa)
  • Maximum Chlorine Concentration: < 0.1 PPM
  • Maximum Operating Temperature: 113 °F (45 °C)
  • pH Range, Continuous (Cleaning): 2-10 (1-12)
  • Maximum Feedwater Turbidity: 1.0 NTU
  • Maximum Feedwater SDI (15 mins): 5.0
  • Maximum Feed Flow: 16 GPM (3.6 m³/h)
  • Minimum Ratio of Concentrate to Permeate Flow for any Element: 5:1
  • Maximum Pressure Drop for Each Element: 15 psi

Note: The limitations shown are for general use. For specific projects, operating at more conservative values may ensure the best performance and longest life of the membrane.

Mechanical / hydraulic

Dimensions:

ParameterValue
A40.0 inches (1016 mm)
B3.95 inches (100.3 mm)
C0.75 inches (19.1 mm)
Weight8 lbs. (3.6 kg)
  • Core tube extension = 1.05" (26.7 mm)
  • All membrane elements are supplied with a brine seal, interconnector, and o-rings.
  • Elements are enclosed in a sealed polyethylene bag containing less than 1.0% sodium meta-bisulfite solution, and then packaged in a cardboard box.

Disclaimer: This summary is based solely on the provided text extract. It may not include all figures, footnotes, or the latest revisions present in the official OEM PDF datasheet. For contractual data, always refer to the specific OEM PDF revision used on your project.

Official datasheet (PDF)

PDF datasheet

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.