Quay lại CMS Membranes
Toray logo

Tóm tắt tài liệu kỹ thuật

CSM UE2010

Engineering summary from PDF text extraction for CSM UE2010. Verify every value with the OEM datasheet.

Summary

Product identification

  • Model Name: UE2010
  • Application: UF element for residential use
  • Membrane Type: Thin-Film Composite
  • Membrane Material: Polysulfone (PSF)
  • Element Configuration: Spiral-Wound, Tape Wrapping

Performance

The stated product performance is based on data taken after 30 minutes of operation at the following test conditions:

  • Pure water (2 MΩ) at 20 psig applied pressure

  • 100% recovery

  • 77°F (25°C)

  • Permeate flow rate for each element may vary +15% / -15%.

  • Permeate Flow Rate: 450 GPD (1,703 L/day)

  • Molecular Weight Cut Off (MWCO): 100K

Operating limits

  • Max. Operating Pressure: 125 psi (0.86 MPa)
  • Max. Feed Flow Rate: 2 gpm (0.45 m³/hr)
  • Max. Operating Temperature: 113°F (45°C)
  • Operating pH Range: 3.0 – 10.0
  • Max. Turbidity: 1.0 NTU
  • Max. SDI (15 min): 5.0

Mechanical / hydraulic

  • Element Dimensions (UE2010):
    • A: 0.67 inch (17 mm)
    • B: 0.55 inch (14 mm)
    • C: 11.73 inch (298 mm)
    • D: 0.98 inch (25 mm)
    • E: 1.89 inch (48 mm)

Handling and storage

  • Elements are supplied as Wet-type, soaked in a preservative solution (1.0% food grade SBS, also described as 1% sodium metabisulfite solution) and vacuum sealed in a poly bag. All elements are individually boxed.
  • Elements in boxes must be kept dry at room temperature (7–32°C; 40–95°F) and should not be stored in direct sunlight.
  • Permeate from the first hour of operation should be discarded.
  • Keep elements moist at all times after initial wetting.
  • Avoid excessive pressure and flow spikes.
  • Only use chemicals compatible with the membrane elements and components; incompatible chemicals may void the element limited warranty.
  • Permeate pressure must always be equal to or less than the feed/concentrate pressure. Damage caused by permeate back pressure voids the element limited warranty.

Certifications

  • Certified to NSF/ANSI 58

Disclaimer: This summary is based on extracted text and may not include all figures, footnotes, or the latest revisions from the original PDF datasheet. For contractual data, always refer to the specific OEM PDF revision used on your project.

Official datasheet (PDF)

PDF datasheet

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.