Quay lại Speck Pumps
Speck logo

Tóm tắt tài liệu kỹ thuật

Speck P51 135 90Bz L

PDF datasheet mirror for Speck P51 135 90Bz L (Speck Pumps). Verify with OEM before design.

Summary

Product identification

The SPECK P51 series consists of high-pressure plunger pumps.

Models covered:

  • P51/135-90 (Code No. 00.5088)
  • P51/135-90Bz (Code No. 00.4448)

Operating limits

  • Data provided is for intermittent operation; data for continuous operation is available on request.
  • Intermediate values for output/speed and pressure/output/kW can be established by linear extrapolation.
ParameterValueUnit
Power Consumption23,8kW
Pressure, max90bar
RPM, max800min⁻¹
Output, max134,1l/min
Water Temperature, max60°C
NPSH Required7,8mWs

A safety valve must be installed to ensure the operating pressure is not exceeded by more than 10%. Exceeding temperature or speed limits, or operating without a safety valve, voids the warranty. Cavitation must be avoided, especially when pumping warm water.

Feed water

SPECK TRIPLEX Plunger Pumps are suitable for pumping clean water and other non-aggressive or abrasive media with a specific weight similar to water. Prior to pumping any other media, suitability and resistance of the pumps (standard or special versions), considering performance and temperature values, must be checked.

Mechanical / hydraulic

  • Plunger diameter: 42 mm
  • Stroke: 42 mm
  • Weight (approx.): 60,0 kg

Construction Characteristics:

  • Crankcase of solid spheroidal-cast iron for high stability and vibration dampening.
  • Crankshaft with taper roller bearings and plain bearing con rod, all running in oil.
  • Solid ceramic plunger.
  • Double plunger sealing.
  • Drip-return system for long seal-life and drip-free operation.
  • All gaskets held in seal sleeves for precise centring and easy replacement.
  • Identical suction and discharge valves, easily accessible via plugs.

Materials Used:

  • Valve Casing: Special Brass (P51/135), Bronze (P51/135 Bz)
  • Plunger: Solid ceramic
  • Valves: High-Grade Stainless Steel
  • Sleeves: Nitrile with fabric reinforcing
  • Crankshaft: Drop-forged and case-hardened

General Power Calculation Formula: P (bar) x Q (l/min) = kW / 475

Special Versions

  • P51/135 'RE': Available with valve casing and wetted parts of AISI 316Ti stainless steel.
  • P51/135 'S': Available with bronze valve casing and stainless steel wetted parts.
  • Special seals are available upon request.

Disclaimer: This summary is based on extracted text and may miss figures, footnotes, or recent revisions from the original OEM PDF. Contractual data must always match the specific OEM PDF revision used for the project.

Official datasheet (PDF)

Lenntech datasheet mirror

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.