Quay lại Flygt Pumps
Flygt logo

Tóm tắt tài liệu kỹ thuật

HS 5570.180

PDF datasheet mirror for HS 5570.180 (Flygt Pumps). Verify with OEM before design.

Summary

Product identification

  • Model: HS-5570 Submersible Pump
  • Description: Abrasion Resistant Slurry Pump, ideal for pumping abrasive slurries, providing high wear resistance and utmost dependability.
  • Approval: CSA approved to UL Standard #778.

Electrical

  • Motor:
    • Air filled, NEMA design B with class H (180°C) insulation.
    • 4 pole or 6 pole.
    • Shrink-fit to the motor housing.
    • Allows at least 15 starts per hour.
    • Built-in thermal sensors for additional motor overload protection.
  • Bearings: Different bearing arrangements available depending on the drive selection.
  • Controls: Manual and automatic controls available upon request.

Mechanical / hydraulic

  • Cable: Standard 50 ft. of SubCab cable.
  • Junction Chamber: Cable entry incorporates a strain relief and grommet controlled compression sealing.
  • Pump Housing:
    • High strength, cast iron ASTM A48 Class A536 No 80-55-06 body.
    • Split volute design with easily replaceable wear lining of high-chrome cast iron ASTM A532 Alloy III A.
    • Static seals are leakproof Nitrile rubber O-rings in precision machined grooves, with controlled compression.
  • Shaft: Stainless steel AISI 431.
  • Shaft Seals:
    • Special design, including an expeller which protects the seal from direct particle intrusion from the hydraulic end.
    • Independent double face seals running in environmentally friendly, FDA approved (Standard #172.878) lubricant.
    • Upper seal: tungsten carbide/tungsten carbide.
    • Lower seal: tungsten carbide/tungsten carbide.
  • Impeller: Non-clog closed type impellers. Material: high-chrome cast iron AISI 532-80 Alloy III A.
  • Wear Ring: Material: AISI 532-8 alloy lll A high chrome cast iron.
  • Strainer: Painted steel AISI A248 Grade D; A 573 Grade 65.
  • Fasteners: Stainless steel AISI 316.
  • Options: Agitator (helps re-suspend settled solids).
  • Accessories: Base stand (sled).

Disclaimer: This summary is based on extracted text and may miss figures, footnotes, or revisions present in the full OEM PDF. Contractual data must always match the specific OEM PDF revision used on the project.

Official datasheet (PDF)

Lenntech datasheet mirror

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.