Quay lại Bel Pressure Vessels
BEL logo

Tóm tắt tài liệu kỹ thuật

BEL i-lEC membranes with BEL Vessels

Engineering summary from PDF text extraction for BEL i-lEC membranes with BEL Vessels. Verify every value with the OEM datasheet.

Summary

Product identification

The iLEC connection system utilizes DOW FILMTEC Membranes.

Mechanical / hydraulic

The iLEC connection system is unique due to its length of 40.5 inches, whereas other manufacturers typically provide a 40-inch dimension. This additional 0.5 inches per membrane accumulates when elements are interconnected.

This design necessitates two types of End Caps for pressure vessels:

  • Standard End Cap: Attached to the rejecting side of the pressure vessel. This end cap provides a Thrust Ring to distribute the forces from membranes during operation.
  • Short End Cap: Must be located on the pressure vessel’s feed side.

Incorrect placement of these End Caps can cause damage to the membranes during operation.

For BEL Solution, BEL Standard Adapters are strictly used.

To simplify membrane loading, especially as membranes are installed by turning and operators' hands may be soaked in glycerin (lubricant), the use of a grip wrench is recommended. The grip wrench must be sized appropriately to tighten 8-inch membranes.


Disclaimer: This summary is based on the provided text extract. It may not include all figures, footnotes, or the latest revisions found in the official OEM PDF datasheet. For contractual data, always refer to the specific OEM PDF revision used on the project.

Official datasheet (PDF)

PDF datasheet

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.