Quay lại 3M-Liqui-Cel® Membrane Contactors
3M logo

Tóm tắt tài liệu kỹ thuật

MM Series 0.5 x 1

Engineering summary from PDF text extraction for MM Series 0.5 x 1. Verify every value with the OEM datasheet.

Summary

Product identification

3M™ Liqui-Cel™ MM-0.5x1 Series Membrane Contactor

Operating limits

  • Liquid Flow Guidelines: 5 – 30 ml/min (Liquid must flow on the shellside)
  • Maximum Shellside LIQUID Working Temperature/Pressure:
    • 5-25°C, 3.1 barg (41-77°F, 45 psig)
    • 40°C, 1.0 barg (104°F, 15 psig)
    • Note: Liquid pressure should always exceed gas pressure.

Mechanical / hydraulic

  • Dimensions (nominal values):
    • 55 mm (2.2 in)
    • 55 mm (2.2 in)
    • 30 mm (1.2 in)
    • 13 mm (0.5 in)
    • See full housing drawing on 3M.com/Liqui-Cel for additional details.
  • Typical Properties:
    • Membrane Type: X50
    • Membrane/Potting Material: Polypropylene / Epoxy
    • Cartridge Configuration: No Baffle Membrane Array Design
    • Priming Volume (approximate) - Shellside: 3.5 ml
  • Housing Characteristics:
    • Material: Polycarbonate
    • Connections:
      • Shellside (Liquid Inlet/Outlet): 1/4 inch Straight Tube
      • Lumenside (vacuum): 1/4 inch Straight Tube
    • Weight (approximate) - Dry: 10 grams
  • Pressure Drop:
    • In all flow rates up to 30 ml/min, the pressure drop is < 0.014 bard (0.2 psid).

Regulatory

  • Complies with the limits as set by RoHS Directive 2011/65/EU Annex II; recasting 2002/95/EC.
  • Constructed of FDA CFR title 21 compliant materials for wetted parts only at ambient temperatures.

Disclaimer: This summary is based on extracted text and may miss figures, footnotes, or subsequent revisions present in the full OEM PDF datasheet. Contractual data for projects must match the specific OEM PDF revision used for that project.

Official datasheet (PDF)

PDF datasheet

Nội dung tổng hợp từ tài liệu kỹ thuật công khai nhằm tra cứu và so sánh sơ bộ. Bản tóm tắt không thay thế bảng dữ liệu hiện hành được nhà sản xuất chứng nhận. Kiểm tra phiên bản và giới hạn thiết kế trước khi sử dụng.